How to Make Lucite and Brass Pulls for Your Drawer or Door

If you're looking to add a touch of elegance to your home decor, making lucite and brass pulls is a great DIY project that can be completed with minimal tools and materials. In this article, we'll guide you through the process of creating these stunning hardware pieces.

Before starting, it's essential to note that this project requires some patience and attention to detail. The pieces need to fit snugly together, so it may take some trial and error to get everything just right.

To begin, cut four dowel rods to the desired lengths using a miter saw or a hand saw. These rods will serve as the base for your lucite and brass pulls. Next, cut two shorter pieces, approximately 0.5″ long, which will be used for the inside of the plumbing tee and won't be visible.

Now it's time to assemble the pieces. Insert the dowel rods into the plumbing tee, making sure they fit snugly. You may need to use a hammer to get them in place. Once the rods are securely in the tee, sand the edges of the pieces that will be visible. These are the areas where the screws will be drilled.

Cut two more pieces, slightly longer than the first set, which will serve as the handles for your lucite and brass pulls. Sand these pieces to smooth out any rough edges.

Now it's time to attach the hardware. Use wood screws to secure the handles to the dowel rods. Make sure to measure carefully to ensure that the screws are spaced evenly.

To add a touch of elegance, you can use acrylic rods instead of dowel rods. This will give your lucite and brass pulls an elegant, high-end look.

Once the hardware is attached, it's time to add some finishing touches. Use metal spray primer to give the copper plumbing tees a good coat of protection. Then, apply two coats of your desired color using spray paint. Finally, use fine-grit sandpaper to rough up the metal before priming.

Tips and Variations

• If you're looking for a more rustic look, you can stain the wood instead of painting it.

• To add some extra flair, you can glue small decorative pieces onto the handles or the dowel rods.

• Consider using washers with your screws to add an extra layer of protection and stability.

Making lucite and brass pulls is a fun and rewarding DIY project that can add a touch of elegance to any room. With these simple steps, you can create beautiful hardware pieces that will complement your existing decor. So why not give it a try? With a little patience and creativity, you can create stunning lucite and brass pulls that will make your home stand out.

Lucite and brass pulls